Radio-shack Audio/ Video Remote Control Manual de usuario descargar pdf (Pagina 8)

Need help? Call

1-888-284-8735

AUX 2

, or

PLUG ’N POWER

), then hold down

until the red light blinks twice.

4. Enter the 4-digit code.

For example, to replace a Panasonic TV’s

remote control (set-up code 0051), press

hold down

until the red light blinks twice, then

enter

0 0 5 1

When the red light blinks twice, the remote con-

trol has accepted the code.

Note:

If you enter an invalid code, the red light

makes one long blink.

5. Point the 6-in-One at your device and press

POWER

. Your TV should turn off.

If the remote does not operate your device, try the

other codes you wrote down in Step 1.

To Operate Your TV/VCR Combination

1. Refer to “TV/VCR Combinations” on Page 37

and write down the codes for your TV/VCR com-

bination on the supplied label.

Notes:

• Some manufacturers have several codes

listed. Try each until you find the right one.

See “Searching for a Code” on Page 48 if you

cannot find the correct code.

• Some TV/VCR combinations require a sec-

ond code to control volume. If you cannot

control volume, use one of the codes listed

for your brand in “TV/VCR Combinations.”

2. Turn on your TV/VCR combination and insert a

tape.

15-1994.fm Page 8 Tuesday, February 29, 2000 2:04 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Sin comentarios

Radio-shack Audio/ Video Remote Control Manual de usuario Pagina 8